2n M2M Solution 2N SmartCom - User Manual 1.9.0 Instrukcja Użytkownika Pobierz pdf (Strona 21)

212N TELEKOMUNIKACE a.s., www.2n.cz

3.2 GSM LED Indicator

Here the variable statuses of the server connection indicating LED are described. This

LED can have two functions: signals the terminal connection to GPRS in the

stand-alone mode and to the SC server in the TCP client mode both for 2N

and . SmartCOM 2N SmartCOM

PRO

For , however, set the scchled1 parameter to determine2N SmartCOM PRO ETH

whether the LED shall signal the GSM or ETH interface state.

Figure: Front Panel with LED Indicator

NO LIGHT – POWER OFF – indicates that the 12V power supply of the GPRS

module is disconnected or works erroneously, or the fuse is defective.

THREE QUICK FLASHES – START or RESTART – indicates the system start or

restart. This status must occur whenever the power supply is connected.

SLOW FLASHING – INITIALISATION – indicates the process of module login to

the provider and IP network.

VERY QUICK FLASHING – ERROR – indicates an error due to a wrong PIN,

missing SIM card, or fewer than three remaining PIN entering attempts.

CONSTANT SHINING – OK – logged in, IP address assigned,2N SmartCOM

connection successfully established. A quick flash indicates data transmission in

this status.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 148 149

Brak uwag

2n M2M Solution 2N SmartCom - User Manual 1.9.0 Instrukcja Użytkownika Strona 21