2n M2M Solution 2N SmartCom - User Manual 1.9.0 Instrukcja Użytkownika Pobierz pdf (Strona 45)

452N TELEKOMUNIKACE a.s., www.2n.cz

Enter the command to set the count of rings before automatic answering to 5.

The port is automatically switched into the transparent modes after an incoming

RING.

at^sc232at=1

Enter the command to set the AT mode upon power up.

0 - disabled. The port will be in the DATA mode upon power up.

1 - enabled. The port will be in the CMD mode upon power up.

at^sc232at?

Enter the command to display the automatic AT mode setting state.

at^sc232at=?

Enter the command to to display the automatic AT mode setting options.

at^sccfgall?

Enter the command to display the currently set values for all interfaces.

^SCCFG: "MODE","TCPCLIENT"

^SCCFG: "GPRS_APN","internet.t-mobile.cz"

^SCCFG: "GPRS_USER","internet"

^SCCFG: "GPRS_PASS","internet"

^SCCFG: "LOCAL_IP","85.44.9.234"

^SCCFG: "SERVER_IP","90.182.12.134"

^SCCFG: "SERVER_PORT",1620

^SCCFG: "AUTH_PASS","hjwej549f"

^SCCFG: "SIM_PIN","2494"

^SCCFG: "AUTH_IP",0

^SCPORT1: "BAUDRATE",115200

^SCPORT1: "DATA_BITS",8

^SCPORT1: "STOP_BITS",1

^SCPORT1: "PARITY",0

^SCPORT1: "FLOWCONTROL",0

^SCPORT2: "BAUDRATE",115200

^SCPORT2: "DATA_BITS",8

^SCPORT2: "STOP_BITS",1

^SCPORT2: "PARITY",0

Access Authorisation According to IP Addresses

These commands are used for setting 5 IP addresses authorised for access to this

terminal. Connections coming from other IP addresses will be ignored.

at^sccfg="auth_ip",1

Switch on / off access authorisation according to IP addresses.

at^scipauth="add","54.182.153.21"

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 148 149

Brak uwag

2n M2M Solution 2N SmartCom - User Manual 1.9.0 Instrukcja Użytkownika Strona 45